Mold Cavity Pressure Sensor Kistler Model 6159A
|
The quartz sensor for mold cavity pressure Type 6159A has a front of 2.5 mm diameter. An O-ring seals the annular gap of < 10 microns between sensor and mounting bore and thereby also center aligns the sensor in the bore. The pressure acts directly on the entire front of the sensor and is transferred to the quartz measuring element, which produces and electrical charge proportional to the pressure. All parts of the sensor are corrosion-resistant. The exchangeable cable is screwed to the sensor with a tight seal. The Mold Cavity Pressure Sensor Kistler Model 6159A is provided with a single-wire cable with a very small cross-sectional area and can be installed flexibly in the injection mold. The single-wire cable is exchangeable and can be cut to length as required. With the single-wire technique, electrical shielding is provided by the mold. It is therefore essential for the cable and connector to be completely integrated in the mold. To ensure easy installation, a connector is included which is self-locking and splash-proof. With multi-cavity system, the sensor basic type is supplied with a single-wire cable, but without connector and mounting plate. |
Mold Cavity Pressure Sensor Kistler Model 6159A for cavity pressures up to 2000 bar for injection molding of plastics.
 |